费森4008s常见故障排除
Fresenius Medical Care
洗肾机故障排除
A T1-Test自我测试
B 模组
C 水路
D 电路
E 消毒及清洗
F 透析过程
A：T1-Test自我测试
故障（状况）检查处理/说明
压力部份
F25 pos pressure F26 pos pressure 1、重校正TMP
2、重校TMP后时好时出现F25或
F26
3．Diasafe filter堵塞
4. 43阀堵塞，24阀短路，26阀漏
5. 43阀后有堵塞现象，排水管太长
排水时有阻力。
1、1、T MP sensor 感测器不稳定，零点偏移
1、2、更换TMP sensor
F02 pos pressure 1. 经由V26的装载压15秒内无法检
测到(小于600mmHg)
V26没法打开,V43无法关闭,检查V24,
V24b是否关闭严密.可能V26问题.
F03 pos pressure 6号传感器连线断
F27 pos pressure 1.V43 filter clotted.
2.V189 clotted.漏
3.24阀短路,漏 4.取样阀有漏，可能伴随HPU F02
出现
可能会引起黑屏显现.
F20 pos pressure
Flow of时压力下降大于80mmHg 1、检查V43和filter/o-ring
2、检查V26和V84之间的连接块，
84阀漏
3、检查透析外管
4．Balance system（V31-V38）leak，
maybe lead to F21 onlineplus within
T1-test
5. C点节流阀有漏，可能有F25 pos
1、V43的filter因时间长而破损造成漏水
2、连接块破裂而漏水
3、NO. 73过滤器密封不好或红蓝接头的
o-ring磨损
F11 pos pressure 1．V24b，V43，V26 漏。
V24B 有沉淀致使漏.
Leica
Motor-Focus
System
User manual
Manuel d’utilisation
Gebrauchsanweisung
Manual de empleo
3Contents
Description . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4Safety concept . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4Overview . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .6
AssemblyThe components . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .7Assembly . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .8
UseSwitching on and off . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .9Acoustic signal . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .9Stops . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .9Footswitch . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .9Handswitch . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .10The focusing position: Storing, travelling, cancelling . . . . . . . . . . . . . . . . . . . . . . . . .10Focusing with the PC . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Release Notes
Metered, Switched, Metered-by-Outlet, and
Metered-by-Outlet with Switching Rack PDUs
Released: February 2016
Applicable Rack PDUs:
AP88XX Metered Rack PDU
AP89XX Switched Rack PDU
AP84XX Metered-by-Outlet Rack PDU
AP86XX Metered-by-Outlet with Switching Rack PDU
Affected Revision Levels
Component File Details
APC Operating System
apc_hw05_aos_640.bin
Network Management Card Operating System &
TCP/IP Stack for Hardware Platform v05
Rack PDU2 Application
apc_hw05_rpdu2g_640.bin
Switched/Metered Rack PDU2
PowerNet® Application
powernet415.mib
PowerNet SNMP Management Information Base
(MIB)
For details on upgrading the firmware, see the User Guide on the APC website, .
Schneider Electric Device IP Configuration Wizard
The Device IP Configuration Wizard is a Windows application designed specifically to remotely configure the basic
Home » BAFANG » BAFANG DP C230 Torque Sensor Mid Drive System User Manual
BAFANG DP C230 Torque Sensor Mid Drive System
Contents1 IMPORTANT NOTICE2 INTRODUCTION OF DISPLAY3 PRODUCT DESCRIPTION3.1 Specifications3.2 Functional Overview4 DISPLAY5 KEY DEFINITION6 NORMAL OPERATION6.1 Switching the System ON/OFF6.2 Selection of Support Levels6.3 Headlights / backlighting6.4 Walk Assistance6.5 Selection Mode6.6 Display of battery capacity6.7 USB charging function6.8 SERVICE7 SETTINGS7.1 “Setting”7.2 “TRIP Reset” Reset mileage7.3 “Unit” Selections in km/Miles7.4 “Sensitivity” Automatic Headlight sensitivity7.5 “Brightness” Display brightness7.6 “Auto Off” Set Automatic system switch offtime7.7 “Vibration” Selection vibration function7.8 “Service” Switching the notification on and off7.9 “Information”7.10 Wheel Size and Speed Limit7.11 Battery Information7.12 Controller Information7.13 Display Information7.14 Torque Information8 Error Code9 ERROR CODE DEFINITION10 Documents / Resources11 Related Posts
