RCN02M1PPEB550015中文资料

RCN02 Resistors

1/2 Chip type attenuator (π type)

RCN02

zFeatures 1) Compare with single type 2) Guarantee the attenuation (±0.3db, ±0.5db) 3) Mounting area 50% less 4) Big reduction for mounting cost (3 times → Once)

zQuick reference The design and specifications are subject to change without prior notice. Before ordering or using, please check the latest technical specifications.

RCN02(0404)

101050Ω

No. of elementsNo. of terminalsPart No.Size codeOperatingtemperature rangeRated power(70°C)Voltage standing wave ratioImpedance

(°C)

340.04W / package−55 to +125MAX 1.3

zExternal dimensions (Unit: mm)

0.331.0±0.11.0±0.1+0.1−0.050.34+0.05−0.1

R1R2R243

120.35±0.1

0.25±0.10.2±0.1

Equivalent

Circuit Diagram

Marking (Terminal No.4)

元器件交易网www.cecb2b.comRCN02 Resistors

2/2 zProduct designation

Packaging Specifications CodeCRN0M135003AM1Part No.CodeSpecificationCodeAttenuationA3 50011dBA3 50022dBA3 50033dB±0.3dB±0.5dB±0.8dB±1.5dB±2.0dB±2.5dBA3 50044dBA3 50055dBA5 50066dBA5 50077dBA5 50088dBA5 50099dBA5 5001010dBA8 5001111dBA8 5001212dBA8 5001313dBB5 5001414dBB5 5001515dBB5 5001616dBC0 5001717dBC0 5001818dBC0 5001919dBC5 5001920dBLimitationPPEπ CircuitPackaging specificationsReel10,000Basic ordering unit (pcs)Part No.Attenuation, Attenuation limitationCircuitPPE2

Reel (φ180mm) : Compatible with JEITA standard "EIAJ ET-7200B"φ180mm (7in.)Paper tape (2mm Pitch)

zPackaging 020406080 20 40 60 8CABD

ABCDφ180 0−1.5φ60 +109 +1.0

0φ13±0.2

P0

P2

B0A0

EFW

T2

φD

0

P1

Label

ReelTaping

EIAJ ET-7200B compliantThick papermount(Underside paper tape)Square punchout hole

Chip attenuatorHeat crimp cover / Tape

Caution : Insertion direction of device to carrier tape. Marking is on the left bottom side of the cavity to the feeding direction.

(Unit : mm)(Unit : mm)WFEA0B0

D0P0P1P2T2

8.0±0.33.5±0.051.75±0.11.17±0.11.17±0.1

φ1.5 +0.104.0±0.12.0±0.12.0±0.05Max. 0.5

Feeding direction

元器件交易网www.cecb2b.com Appendix

Appendix1-Rev1.1 The products listed in this document are designed to be used with ordinary electronic equipment or devices (such as audio visual equipment, office-automation equipment, communications devices, electrical appliances and electronic toys).Should you intend to use these products with equipment or devices which require an extremely high level of reliability and the malfunction of with would directly endanger human life (such as medical instruments, transportation equipment, aerospace machinery, nuclear-reactor controllers, fuel controllers and other safety devices), please be sure to consult with our sales representative in advance.

NotesNo technical content pages of this document may be reproduced in any form or transmitted by any means without prior permission of ROHM CO.,LTD.The contents described herein are subject to change without notice. The specifications for theproduct described in this document are for reference only. Upon actual use, therefore, please requestthat specifications to be separately delivered.Application circuit diagrams and circuit constants contained herein are shown as examples of standard use and operation. Please pay careful attention to the peripheral conditions when designing circuitsand deciding upon circuit constants in the set.Any data, including, but not limited to application circuit diagrams information, described herein are intended only as illustrations of such devices and not as the specifications for such devices. ROHM CO.,LTD. disclaims any warranty that any use of such devices shall be free from infringement of anythird party's intellectual property rights or other proprietary rights, and further, assumes no liability of whatsoever nature in the event of any such infringement, or arising from or connected with or related to the use of such devices.Upon the sale of any such devices, other than for buyer's right to use such devices itself, resell or otherwise dispose of the same, no express or implied right or license to practice or commercially exploit any intellectual property rights or other proprietary rights owned or controlled by ROHM CO., LTD. is granted to any such buyer.Products listed in this document are no antiradiation design.

About Export Control Order in JapanProducts described herein are the objects of controlled goods in Annex 1 (Item 16) of Export Trade ControlOrder in Japan.In case of export from Japan, please confirm if it applies to "objective" criteria or an "informed" (by MITI clause)on the basis of "catch all controls for Non-Proliferation of Weapons of Mass Destruction.