[1] H.C. Furtado，L.H. de Almeida，I. Le May．Precipitation in 9Cr–1Mo
steel after creep deformation[J]．Materials Characterization，2007，58：72–77．
[2] Sasaki，Terufumi，Kobayashi，et al．Production and properties of
seamless modified 9Cr-1Mo steel boiler tubes[R]．Kaw asaki Steel Technical Report，1991，25(4)：78-87．
[3] Ahmed Shibli，Fred Starr．Some aspects of plant and research
experience in the use of new the phase stability of precipitates in low Cr Inside Bore and Lamination Defects in Rotary Piercing for Materials with Poor Hot Workability [J]．ISIJ International，1997，37(2)：．
[4] Ken-ichiro Mori，Hidenori Yoshimura，Kozo Osakada．Simplified
three- dimensional simulation of rotary piercing of seamless pipe by rigid-plastic finite-element method[J]．Journal of Materials Processing Technology，1998，80-81：．
[5] Y van Chastel，Aliou Diop，Silvio Fanini，et al．Finite Element
Modeling of Tube Piercing and Creation of a Crack[J]．Int J Mater Form，2008，Suppl 1：．
[6] Hyoung Wook Lee，Geun An Lee，Eung Kim，et al．Prediction of plug
tip position in rotary tube piercing mill using simulation and experiment[J]．International Journal of Modern Physics B，2008，22(31-32)：．
[7] Kazutake Komori．Simulation of Mannesmann piercing process by
the three-dimensional rigid-plastic finite-element method[J]．International Journal of Mechanical Sciences，2005，47：．
[8] Hayashi C，Yamakawa T．Influence of feed and cross angle on rotary
forging effects and redundant shear deformation in rotary piercing process[J]．ISIJ International，1997，37：．
[9] A Ghiotti，S Fanini，S Bruschi，et al．Modeling of the Mannesmann
effect[J]．CIRP Annals-Manufacturing Technology，2009，58：．[10] E.I. Panov．Shear Stresses and Their Dependence on Different Process
Parameters in The Helical Rolling of Solid Semifinished Products[J]．Metallurgist，2005，49(7-8)：．
[11] E.I. Panov．Certain Aspects of The Stress-Strain State of Semifinished
Products in Helical Rolling[J]．Metallurgist，2003，47(11-12)：．[12] E.I. Panov．Effect of thrust and tension on the radial stresses in of
the tube forming process in Diescher’s mill [J]．Journal of Materials Processing Technology，2006，177：．
[13] J C Prince，R Maroño，F León．Thermomechanical analysis of a
piercing mandrel for the production of seamless steel tubes[J]．J.
Process Mechanical Engineering，2003，217：．
[14] K azutake Komori，Kouta Mizuno．Study on plastic deformation in
cone-type rotary piercing process using model piercing mill for modeling clay[J]．Journal of Materials Processing Technology，2009，209：．
[18] Kazutake Komori, Kouta Mizuno. Study on plastic deformation in
cone-type rotary piercing process using model piercing mill for modeling clay [J]. Journal of Materials Processing Technology, 2009, Vol. 209, pp..
[19] J C Prince, R Maroño, F León. Thermomechanical analysis of a
