S-AV5中文资料

NE5532中文资料(引脚图,特点及电气参数介绍)
电气参数
NE5532中文资料(引脚图,特点及电气参数介绍)
NE5532功能特点简介:
NE5532/SE5532/SA5532/NE5532A/SE5532A/SA5532A是一种双运放高性能低噪声运算放大器。

相比较大多数标准运算放大器，如1458，它显示出更好的噪声性能，提高输出驱动能力和相当高的小信号和电源带宽。

这使该器件特别适合应用在高品质和专业音响设备，仪器和控制电路和电话通道放大器。

如果噪音非常最重要的，因此建议使用5532A版，因为它能保证噪声电压指标。

NE5532特点：
•小信号带宽：10MHZ
•输出驱动能力：600Ω，10V有效值
•输入噪声电压：5nV/√Hz(典型值)
•直流电压增益：50000
•交流电压增益：2200-10KHZ
•功率带宽： 140KHZ
•转换速率： 9V/μs
•大的电源电压范围：±3V-±20V
•单位增益补偿
NE5532引脚图：
图1 NE5532 8脚引脚图图2 NE5532 16脚封装引脚功能图NE5532内部原理图:
图3 5532内部电路图
NE5532电气参数:
DC ELECTRICAL CHARACTERISTICS直流电气特性
AC ELECTRICAL CHARACTERISTICS交流电气特性
ELECTRICAL CHARACTERISTICS电气特性
测试电路：
.
图4 闭环频率响应图5 电压跟随电路。

50 Ω 10 Ω + 0.5 A D.U.T. 50 Vdc (approx ) 1Ω PULSE GENERATOR ( NOTE 2 ) OSCILLOSCOPE ( NOTE 1 ) 0 - 0.25 A Trr
+
- 1.0 A SET TIME BASE FOR 50/100 ns/cm
NOTES : 1. Rise Time = 7 ns max., Input Impedance = 1 megaohm, 22 pF. 2. Rise time = 10 ns max., Source Impedance = 50 ohms. 3. All Resistors = Non-inductive Types.
元器件交易网
SRTA - SRTM
PRV : 50 - 1000 Volts Io : 2.5 Amperes
FEATURES :
* * * * * * High current capability High surge current capability High reliability Low reverse current Low forward voltage drop Fast switching for high efficiency
Rating at 25 °C ambient temperature unless otherwise specified. Single phase, half wave, 60 Hz, resistive or inductive load. For capacitive load, derate current by 20%.
PEAK FORWARD SURGE CURRENT, AMPERES

最大正向电压
Maximum forward voltage
最大反向电流
Maximum reverse current
最大反向恢复时间
MAX. Reverse Recovery Time
典型结电容
Type junction capacitance
IF = 1.0A
符号
Symbols
VF
TA= 25℃
IR
10mm 10mm
1.2
1.0
0.8
0.6
0.4
0.2 0 0 25 50 75 100 125 150 175
环境温度 Ta(°C) Tamb, ambient temperature (°C)
40
30
20
10
0 1 2 4 6 10 20 40 100
通过电流的周期 Number of Cycles at 60 Hz.
SIYU R
S5295B/ S5295G / S5295J
塑封快恢复整流二极管
反向电压 100 --- 600 V 正向电流 0.5 A
DO-41
1.0(25.4) MIN
.034(0.9) DIA
.028(0.7)
.205(5.2) .166(4.2)
1.0(25.4) MIN
.107(2.7) DIA
浪涌特性曲线（最大值） MAXIMUM NON REPETITIVE PEAK FORWARD SURGE CURRENT
平均正向电流 IF(AV) (A) IF(A) Average Forward Rectified Current (A)
正向电流降额曲线 FORWARD CURRENT DERATING CURVE

Serial Data Output Set-up and Hold Time
The output set-up and hold times are represented by the waveforms shown in Figure 3.
Jitter Generation
The jitter of the serial clock and serial data outputs shall not exceed .01 U.I. when a serial data input with less than 14ps rms jitter is presented to the serial data inputs.
SONET/SDH/ATM CLOCK RECOVERY UNIT
Pin Name Level I/O Pin # Description
SERDATIP SERDATIN
Diff.
I
PECL
2
Serial data in. A clock is recovered from transitions on these
元器件交易网
DSEOVINCEETS/PSEDCHIF/IACTATMIOCNLOCK RECOVERY UNIT BSOiCNMEOTS/SPDEHC/ALTCMLOCLCOKCGKERNEECROAVTOERRY UNIT
®
S3025 S3025
FEATURES
• Complies with ANSI, Bellcore, and ITU-T specifications for jitter tolerance, jitter transfer and jitter generation