不同氮肥运筹对“南粳5055”机插栽培的影响
- 格式:pdf
- 大小:141.45 KB
- 文档页数:2
南粳5055品种介绍
南粳5055号,又名宁5055号,是江苏省农科院粮食作物研究所育成的,继南粳46号以后的又一个优良食味粳稻新品系。
利用日本优质粳稻与江苏优质高产粳稻杂交,经数代筛选培育而成的优质粳稻。
用这种大米煮成的米饭晶莹剔透,口感柔软润滑,富有弹性,冷后不硬。
2009年8月在全国优质粳稻优良食味品评会上,南粳5055获得三等奖。
2010年,在全省举行的粳稻优质米食味品尝鉴定会上,“南粳5055”获得评比一等奖,综合评分超过日本优质稻米品种越光。
2011年3月9日在“第六届全国粳稻米大会”上,被评为全国“优质食味粳米”,被评为“江苏最好吃的大米”。
食用方法:1.将适量米加入电饭锅,用清水漂洗2-3次;
2.干米于水按1:比例加水,浸泡10-30分钟;
3.蒸煮过程不要揭开锅盖或搅拌米粒;
4.煮熟后闷上10-30分钟。
存储方法:为了保持大米的品质,最好将大米置于温度低于
25℃,湿度小于70%的环境下,开包后请尽快食
用。
现代农业科技2021年第
17期
农艺学
不同施氮量对优质稻南粳46产量的影响
张珍王依明李逸龙张顾旭(上海市浦东新区农业技术推广中心,上海201201)摘要 采用随机区组设计,研究不同氮肥施用量对优质稻南粳46产量的影响。结果表明
,在一定施氮范围内
,水
稻的产量随氮肥用量的提高而增加,但超过一定水平以后
,水稻的产量将不再提高
,建议纯N施用量以
285 kg/hm2
最佳。
关键词水稻;南粳46
;施氮量
;产量
中图分类号S511
; S147.5
文献标识码
A
文章编号 1007-5739
(2021
)17-0011-03
DOI:10.3969/j.issn.1007-5739.2021.17.004
Effects of Different Nitrogen Rates on Yield of High-quality Rice Nanjing 46 ZHANG Zhen WANG Yiming LI Yilong ZHANG Guxu(Pudong New District Agro-technology Extension Center of Shanghai City, Shanghai
201201)
Abstract The effects of different nitrogen rates on yield of high -quality rice Nanjing 46 were studied by using
randomized -block design. The results showed that in a certain range of nitrogen application, the yield of rice increased with
the
increase of nitrogen rate, but after a certain level, the yield of rice would not increase. It is suggested that the best nitrogen rates
Hans Journal of Agricultural Sciences 农业科学, 2023, 13(8), 786-790 Published Online August 2023 in Hans. https:///journal/hjas https:///10.12677/hjas.2023.138111沿淮地区不同氮肥用量对水稻 生长和产量的影响王春姐江苏省农垦农业发展股份有限公司临海分公司,江苏 盐城收稿日期:2023年7月7日;录用日期:2023年8月7日;发布日期:2023年8月14日摘要本试验以南粳9108为研究对象,通过不同施氮量和不同使用时期探讨氮肥对机插水稻生育进程、茎蘖动态以及产量构成因素的影响,结果表明,不同施氮量和施肥模式对生育期影响很小,误差在1天左右。
随着用氮量加大,分蘖性、株高呈上升趋势。
纯氮用量375 kg/hm 2,基肥和分蘖肥均为225 kg/hm 2,不施保花肥的处理产量结构合理,理论产量达到10444.65 kg/hm 2,实际产量达到9737.10 kg/hm 2,均为最高,并且产量三要素较为协调,田间病虫害较轻。
关键词施氮量,施肥模式,生育进程,茎蘖动态,产量Effects of Different Nitrogen Fertilizer Dosages on Rice Growth and Yield in the Huaihe River RegionChunjie WangLinhai Branch, Jiangsu Provincial Agricultural Reclamation and Development Co., Ltd., Yancheng JiangsuReceived: Jul. 7th , 2023; accepted: Aug. 7th , 2023; published: Aug. 14th , 2023AbstractThis experiment takes Nanjing 9108 as the research object, and explores the effects of nitrogen fertilizer on the growth process, stem and tiller dynamics, and yield components of machine in-王春姐serted rice through different nitrogen application rates and periods. The results show that differ-ent nitrogen application rates and fertilization modes have little impact on the growth period, with an error of about 1 day. With the increase of nitrogen usage, tillering ability and plant height show an upward trend. The pure nitrogen dosage is 375 kg/hm2, and the base fertilizer and tiller-ing fertilizer are both 225 kg/hm2. The yield structure of the treatment without applying flower-ing fertilizer is reasonable, with a theoretical yield of 10444.65 kg/hm2and an actual yield of 9737.10 kg/hm2, both of which are the highest. The three factors of yield are relatively coordi-nated, and the field diseases and pests are relatively light.KeywordsNitrogen Application Rate, Fertilization Mode, Fertility Process, Stem and Tiller Dynamics,YieldThis work is licensed under the Creative Commons Attribution International License (CC BY 4.0)./licenses/by/4.0/1. 前言水稻产量高低,与水稻品种、栽培技术、气候条件等因素密切相关。
农业工程技术·综合版 2020年11月刊61栽 培 与 种 植与宁粳1号相比,成熟时间早1天左右;与武运粳7号相比,成熟时间早4天左右,非常适合在江苏地区推广种植。
二、南粳5055产量结构根据南粳5055播种时间与密度进行考量,田块种植亩产量可设置为500 kg。
南粳5055亩有效穗23万~25万穗,穗总粒数130粒左右,结实率90%以上,千粒质量25 g。
三、南粳5055高产栽培技术1、选地整地选择的稻田应地势平坦,排灌条件良好。
应对稻田进行深耕,一般深度在25 cm左右,有助于提升土壤透气性。
然后进行田面平整,做到上软下实。
在整地时,畦田宽度需控制在145~150 cm,沟宽50~45 cm,沟深10~15 cm。
稻田畦面要平整干净,土壤细碎,不能有杂草或其他杂物[2]。
2、适时播种播种时间需要结合当地实际气候条件决定。
江苏省一般6-7月处于大面积降水期,因此需要在5月底至6月初播种,以便后续插秧。
播种时还要考虑当地的土壤温度,一般江苏省5-6月土壤温度较高,符合水稻发芽温度要求。
如果土壤温度不足,可采用土壤测温法合理确定播种时间,从而保障南粳5055的出苗率。
总体而言,南粳5055适宜尽早播种,越早越有利于延长水稻生育期,提高温光资源利用率,增加穗重与产量。
一般要求在5月底到6月10日前播种。
3、定量移栽在进行水稻移栽时,要以秧苗实际长势为依据,一般在6月15日-6月20日左右移栽。
若选择机插秧移栽方式,可将行株距控制在30 cm×12 cm,种植密度一般控制在28万穴/hm 2 左右。
移栽时要带药移栽。
移栽前1天,可以喷施保护药,从而保证水稻苗能够尽快适应新的环境,茁壮生长。
为更好保障机插质量,应在田间浑水沉实后才能机插种植,通常在稻田整平后1~2天。
机插时,应严格遵循薄水浅插、不漂不倒的原则。
在水稻机插前还应注意田面硬度,比较常用的是划地观察法:先将食指插入稻田地面约2 cm 深位置,然后划沟,若感到阻力小,所划出的软泥能够缓慢合拢,说明硬度刚好,非常适合插秧;若阻力较大,说明田面硬度过大,容易伤苗。