摩托车配件中英文对照

摩托车配件中英文对照

摩托车配件中英文对照

名称英文名称

化油器CARBURETOR

前尾FRONT MOLDING

后尾REAR MOLDING

后尾REAR MOLDING

转向灯开关SWITCH WINKER

远近光开关SWITCH LIGHTING

变光开关SWITCH DIMMER

喇叭开关SWITCH HORN

电启动开关SWITCH ELECTRIC START 传感器SENSOR

吊架橡胶衬套RUBBER

车架挡泥板FENDER, FRAME BODY

仪表壳COVER METER

工具箱盖COVER ., TOOL CASE

后泥板FENDER .,RR

摇臂前叉FRONT SWING FORK

双撑MAIN STAND

单撑SIDE STAND

前毂刹FRONT DRUM

消声器垫WASHE MUFFLE

前尾FRONT MOLDING

前尾FRONT MOLDING

后尾REAR MOLDING

后尾REAR MOLDING

高压包IGNITION COIL 前照灯罩COVER ., HEAD LIGHT

右边条RIGHT SIDE COVER

左边条LEFT SIDE COVER

工具箱TOOL CASE

工具箱TOOL CASE

工具箱TOOL CASE

面板COVER SET, FR. TOP

面板COVER SET, FR. TOP

副线缆VICE WIRE HARNESS

主线缆MAIN WIRE HARNESS

后衣架REAR CARRIER

发动机配件

进气管总成INLET PIPE ASS'Y

右曲轴箱盖总成R. CRANK CASE COVER ASS'Y 左曲轴箱盖L.

CRANK CASE COVER

左曲轴箱L. CRANK CASE

主动轮扇叶盘DRIVE FACE

衬套DRIVE FACE BOSS

滑动驱动盘组MOVABLE DRIVE FACE ASS'Y

重垂滚子组WEIGHT ROLLER COMP.

起动从动齿轮(20T) KICK START DRIVEN GEAR(20T) 起动惰扇形齿轮总成STARTER IDLE GEAR ASS'Y.

滑动从动皮带盘组MOVABLE DRIVEN FACE COMP.

驱动弹簧DRIVEN FACE SPRING

冷却风扇盖总成FAN COVER ASS'Y

罩盖A总成SHROUD A ASS'Y

汽缸头盖HEAD COVER COMP.

汽缸头盖垫圈HEAD COVER GASKET

汽缸头垫片CYLINDER HEAD GASKET

隔热板垫片CARB. INSULATOR GASKET 定位梢10×16 DOWEL PIN 10×16

火花塞PLUG SPARK

气门油封STEM SEAL VALVE

凸轮轴CAM SHAFT COMP.

止动板STOPPER PLATE COMP.

气门摇臂VALVE ROCKER ARM

进气门摇臂轴IN ROCKER ARM SHAFT COMP.

排气门摇臂轴EX. ROCKER ARM SHAFT

进气门INLET VALVE

排气门EXHAUST VALVE

气门外弹簧VALVE OUTER SPG.

气门内弹簧VALVE INNER SPG.

气门弹簧座VALVE SPRING RETAINER

气门弹簧垫片WASHER

气门锁夹VALVE COTTER

气门间隙调整螺丝TAPPET ADJUST SCREW

气门间隙调整螺母TAPPET ADJUST NUT

正时链条CAM CHAIN

链条张力器CAM CHAIN TENSIONER

链条调整器总成TENSIONER LIFTER ASS'Y

链条调整器垫片TENSIONER LIFTER GASKET

张力器螺丝总成CAM CHAIN TENSIONER PIVOT ASS'Y 链条导片CAM CHAIN GUIDE COMP.

汽缸垫片CYLINDER GASKET

定位销10×16 DOWEL PIN 10×16

线圈STATOR COMP.

冷却风扇COOLING FAN COMP.

飞轮FLYWHEEL COMP.

机油泵总成OIL PUMP ASS'Y

机油泵驱动链轮OIL PUMP DRIVEN SPROCKET 机油泵驱动链条OIL PUMP CHAIN

机油泵盖板OIL SEPARATER

起动减速齿轮STARTER REDUCTION GEAR

起动减速齿轮轴STARTER REDUCTION GEAR SHAFT 顶销CAP

STARTING ROLLER SPRING

垫圈22.2×31×1 THRUST WASHER 22.2×31×1

半圆键WOODRUFF KET

滚子10×10 ROLLER 10×10

滚针轴承28×32×17 NEEDLE BRG 28×32×17

超越离合器总成START CLUTCH OUTER ASS'Y

通气导板L. CRANK CASE COVER PLATE

左曲轴箱盖垫片L. COVER GASKET

攻丝螺钉4×8 TAPPING SCREW 4×8

固定梢8×14 DOWEL PIN 8×14

滚导梢ROLLER GUIDE PIN

滚子ROLLER GUIDE

螺帽ＣＭ12 FLANGE NUT C M12

特殊螺帽28mm SPECIAL NUT 28mm

传动盘油封34×41×4 DRIVEN FACE SEAL 34×41×4 变速箱盖MISSION COVER

变速箱盖垫片MISSION COVER GASKET

螺栓8mm SPECIAL BOLT 8mm

油封20×32×6 OIL SEAL 20×32×6

定位销8×14 DOWEL PIN 8×14

最终齿轮轴组FINAL GEAR SHAFT ASS'Y

第一道活塞环PISTON RING SET

第二道活塞环PISTON RING 2nd

油环组合PISTON RING OIL

右曲轴箱R. CRANK CASE

引擎吊架橡胶衬套ENG. HANGER RUB. BUSH 曲轴箱垫片CRANK CASE GASTER

刹车片固定销PIN BRAKE SHOE ANCHOR

后避震器下端衬套RR. CUSH UND BUSH RUBBER 双头螺栓8×187.5 A STUD BOLT 8×187.5

双头螺栓8×195.5 B STUD BOLT 8×195.5

轴承6301 RADIAL BALL BEARING 6310

轴承6004 RADIAL BALL BEARING 6004

油封19.8×30×5 OIL SEAL 19.8×30×5

油封27×42×7 OIL SEAL 27×42×7

轴承6002 RADIAL BALL BEARING 6002

定位销8×14 DOWEL PIN 8×14

六角缘面螺栓6×50 FLANGE SH BOLT 6×50

轴承6002 RADIAL BALL BEARING 6002

机油泵盖板OIL SEPARATER

起动马达MOTOR ASS'Y. START

化油器总成CARBURETOR ASSY

从动皮带盘CLUTCH OUTER

驱动板总成DRIVE PLATE ASS'Y.

被动皮带盘总成DRIVE PULLEY ASS'Y 传动盘总成DRIVEN FACE

ASS'Y

油封套环SEAL COLLAR

弹簧轴环SPRING COLLAR