盐雾试验报告模板-中文版
- 格式:doc
- 大小:96.00 KB
- 文档页数:4
日期:Date:
页码:Page 1 of 5 石家庄市金达特种涂料有限公司实验室
********** 按下页**********
试验人员签名:日期:
实验室主管签名:日期:
石家庄市金达特种涂料有限公司
日期:Date:
页码:Page 2 of 5
1.试板制备Preparation of Test Plate:
1.1 基材信息Detail of Substrate
备注:列出上表中关于表面处理需要另外解释和说明的事项。
备注Note:列出上表中关于涂漆过程需要另外解释和说明的事项。
1.3 试板调节Condition of panels before testing
指试板制好后,在什么环境下放置多长时间,相关标准中都有规定,在此加以说明。ISO 12944-6要求在标准气候环境中放置三周)。
备注:1、封边情况、背面处理
日期:Date:
页码:Page 3 of 5
2. According to ISO 4628-2:2003, Blistering classification—Class 0 is best and Class 5 is worst, “S” means the size of bubble.
3. 附着力变化,数值是如何得出的。
日期:Date:
页码:Page 4 of 5
4 试验照片Test Photo(s):
2-1. Before Salt Spray test (Sample 1~6)
2-2. Before Salt Spray test (Sample 1~3) 2-3. After Salt Spray test (Sample 4~6)
2.4. The close-up of defects After Salt Spray test 2.5 The close-up of defects after removed the pressure
(sample 2) -sensitive tape, 24h afterending of Salt Spray test
2.4. The close-up of defects After Salt Spray test 2.5 The close-up of defects after removed the pressure
(sample 2) -sensitive tape, 24h afterending of Salt Spray test
2.6 The close-up of the pressure -sensitive 3M® tape used
******** End *******
测试Tested by:
日期Date:
审核Checked by: 日期Date: