HJV2302_D_I规格承认书

-------------------------------------------------------3
-------------------------------------------------------4
-------------------------------------------------------6
3. ELECTRICAL CHARACTERISTICS 3.1 TFT LCD MODULE
Parameter
Power Supply Voltage Power Supply Ripple Voltage
Symbol VCC VRP IRUSH
Min.
11.4 -100 1.125 2.7 0
1. GENERAL DESCRIPTION 1.1 OVERVIEW 1.2 FEATURES 1.3GENERAL SPECIFICATIONS 1.4 MECHANICAL SPECIFICATIONS 2. ABSOLUTE MAXIMUM RATINGS 2.1 ABSOLUTE RATINGS OF ENVIRONMENT 2.2 PACKAGE STORAGE 2.3 ELECTRICAL ABSOLUTE RATINGS 2.3.1 TFT LCD MODULE 3. ELECTRICAL CHARACTERISTICS 3.1 TFT LCD MODULE
Max
-
Unit
mm mm mm mm g
Weight
第4页
VXIMUM RATINGS 2.1 ABSOLUTE RATINGS OF ENVIRONMENT
Item
Storage Temperature Operating Ambient Temperature Shock(Non-Operating) Altitude Storage
5. PIN CONNECTION
5.1 TFT LCD MODULE 5.2 LVDS Characteristics 5.2.1 Signal Electrical Characteristics for LVDS Receiver 5.2.2 Timing Characteristics 5.3 BACKLIGHT UNIT 5.4 COLOR DATA INPUT ASSIGNMENT 6. OPTICAL CHARACTERISTICS
第5页
VER A
2010.10.19
2.2 PACKAGE STORAGE
When storing modules as spares for a long time, the following precaution is necessary. (a) Do not leave the module in high temperature, and high humidity for a long time. It is highly recommended to store the module with temperature from 0 to 35 at normal humidity without condensation. (b) The module shall be stored in dark place. Do not store the TFT-LCD module in direct sunlight or Fluorescent light.
Unit
mm mm pixel mm color -
Note
(1)
1.4 MECHANICAL SPECIFICATIONS Item
Module Size
Horizontal(H) Vertical(V) Depth(D)rear Depth(D)Max
Min
-
Typ
544.80 320.50 12.6 18.7 2900
R&D
Dept.
QA Dept.
Reviewed By
TV LCM Marketing and Sale Dept.
第1页
VER A
2010.10.19
- CONTENTS –
REVISION HISTORY -------------------------------------------------------3
Symbol
TST TOP SNOP VNOP
Min.
-20 0 -
Value Max.
+60 +50 50 1.0
Unit
ºC ºC G G
Note
(1) (1), (2) (3),(5) (4),(5)
Note (1) Temperature and relative humidity range is shown in the figure below. (a) 90 %RH Max. (Ta ≦ 40 ºC). (b) Wet-bulb temperature should be 39 ºC Max. (Ta > 40 ºC). (c) No condensation. Note (2) The maximum operating temperature is based on the test condition that the surface temperature of display area is less than or equal to 65 ºC with LCD module alone in a temperature controlled chamber. Thermal management should be considered in your product design to prevent the surface temperature of display area from being over 65 ºC. The range of operating temperature may degrade in case of improper thermal management in your product design. Note (3) 11ms, half-sine wave, 1 time for ±X, ±Y, ±Z. Note (4) 10~200Hz, 10 min, 1time each X,Y,Z. Note (5) At testing Vibration and Shock, the fixture in holding the module has to be hard and rigid enough so that the module would not be twisted or bent by the fixture.
第2页
VER A
2010.10.19
REVISION HISTORY
Version Date Page （New） Section Description
1. GENERAL DESCRIPTION
第3页
VER A
2010.10.19
1.1 OVERVIEW
HJV2302 is a 23.6” TFT Liquid Crystal Display module with LED Backlight unit and 1ch-LVDS interface. This module supports 1920 x 1080 WXGA(16:9 wide screen) format and can display 16.7M colors The LED driver module for backlight is not built-in.
1.2 FEATURES
- High Brightness 250 nits - Ultra-high contrast ratio 1000:1 - Faster Response Time (Gray to Gray Average 6.5ms)
- High Color Saturation NTSC 70% - Ultra wide Viewing Angle: 176(H)/176(V) (CR≥20) with Super MVA Technology - DE (Data Enable) Only Mode - LVDS (Low Voltage Differential Signaling) Interface - Color Reproduction (Nature Color)
-------------------------------------------------------20
6.1 TEST CONDITIONS
6.2 OPTICAL SPECIFICATIONS
7. DEFINITION OF LABELS
8.1 ASSEMBLY LCD MODULE LABEL 8. PACKAGING 9.1 PACKING SPECIFICATIONS 9.2 PACKING METHOD
Value Typ.
12.0 0.51 0.4 0.6 1.25 100 -
Max.
12.6 100 3.4 +100 1.375 3.3 0.7
10.1 ASSEMBLY AND HANDLING PRECAUTIONS 10.2 SAFETY PRECAUTIONS 10.3 STORAGE PRECAUTIONS 10. MECHANICAL CHARACTERISTICS -------------------------------------------------------26
1.3 GENERAL
Item
Active Area Bezel Opening Area Driver Element Pixel Number Pixel Pitch (Sub Pixel) Pixel Arrangement Display Colors Display Operation Mode Surface Treatment Specification 521.28 (H) x 293.22 (V) mm (23.6" diagonal) 525.22 (H) x 297.22 (V) a-si TFT active matrix 1920 x R.G.B. x 1080 0.2715 (per one triad) x 0.2715 mm RGB vertical stripe 16.7M Transmissive mode / Normally black Anti-Glare coating (Haze 17%),Hard coating (2H)