Router>
Router:主机名,可更改
>:当前系统配置模式,>表示当前系统配置模式为用户模式
User mode 用户模式
Router>
特权模式
Router>enable
Router#
通用配置模式
Router#configure terminal
Router(config)#
退出上一模式命令:exit
配置主机名:
Router(config)#hostname <你所要配置的主机名>
例子:
Router(config)#hostname BJ-SJS-01
BJ-SJS-01(config)#
配置路由器用户模式密码:
Router(config)#line vty 0 4
Router(config-line)#password <密码>
例子:
Router(config)#line vty 0 4
Router(config-line)#password vfast
配置路由器特权模式密码:
1.铭文特权模式密码:
Router(config)#enable password <密码>
例子:
Router(config)#enable password vfast2009
2.md5加密的特权模式密码:
Router(config)#enable secret <密码>
例子:
Router(config)#enable secret vfast2010
以列表的方式查看本地所有接口
Router#show ip interface brief
配置以太网接口:
1.进入通用配置模式
Router#configure terminal
Router(config)#
2.进入以太网接口配置模式
Router(config)#interface fastethernet <端口号>
例子:Router(config)#interface fastethernet 0/0
Router(config-if)#
3.开启端口
Router(config-if)#no shutdown
4.配置端口IP
Router(config-if)#ip address
例子:
Router(config-fi)#ip address 192.168.1.1 255.255.255.0 查看串口状态命令:show controllers serial <端口号>
配置串口:
1.进入通用配置模式
Router#configure terminal
Router(config)#
2.进入串口配置模式
Router(config)#interface serial <端口号>
例子:Router(config)#interface serial 0/0
Router(config-if)
3.开启端口
Router(config-if)#no shutdown
4.封装PPP
Router(config-if)#encapsulation ppp
5.如果为DCE端需要配置时钟频率,如果为DTE端不要配置时钟频率,配也配不上Router(config-if)#clock rate 64000
6.配置IP
Router(config-if)#ip address
查看本机系统信息
Router#show version
查看本机CPU使用信息
Router#show process
查看本机当前配置命令:
Router#show running-config
查看本机路由表:
Router#show ip route
查看系统时间:
Router#show clock
更改系统时间
Router#clock set
保存路由器配置:
Router#copy running-config startup-config
Router#wr
网线制作:
T568A-T568B:交叉线
T568B-T568B:平行线
交叉线用于相同设备连接平行线用于不同设备连接
交换机-交换机:交叉线
交换机-PC:平行线
交换机-路由器:平行线
交换机-防火墙:平行线PC-PC:交叉线
PC-路由器:交叉线
PC-防火墙:交叉线
路由器-路由器:交叉线
路由器-防火墙:交叉线
防火墙-防火墙:交叉线