1.OBJECT对象
This document explains briefly the PLC's alarms in G9X UC wtg's con PLC Phoenix and DFM converter.本文件简要解释G9X加州风力发电机组的CON PLC菲尼克斯太阳队和DFM转换PLC 的报警。
2.scope范围
This document applies for all wind turbines G9x UC Phoenix DFM.本文件适用于所有G9X菲尼克斯双馈风机。
3.DEFINItions and acronysm定义和acronysm
Alarm: Abnormal situation which force the wtg to stop operation.报警：出现异常情况，强制停止运行的风力发电机组。
4.DESCRIPtioN说明
1.GENERAL description一般说明
Alarm codification by functional groups:由功能团体的报警编纂：
?1xx- Yaw1XX偏航
?2xx – Hydraulic unit.2XX -液压装置。
?3xx - Ambient3XX -环境
?4xx - Gearbox4XX –齿轮箱
?5xx - Generator5xx系列-发电机
?7xx – Communications.7XX -通信。
?8xx - Pitch8XX –变桨
?9xx – Operational states9XX -运行状态
?18xx – Grid connection18xx -电网连接
?21xx - Software21XX -软件
?5xxx – Alarms ruled by CCU DFM V3.2/V3.35XXX - CCU的DFM V3.2/V3.3排除报警Note 1: In the information screen of the alarm, it will be displayed the possible cause of the
alarm or relative data that could help to identify.注1：报警信息屏，它会显示报警或相对的数据，可以帮助确定可能的原因。
Note 2: Atribute value of Avalaibality equal to Yes, means the wtg was available during alarm activation.注2：Avalaibality等于为“是”的属性值，意味着风力发电机组是在报警激活。
2.criteria description标准描述
Alarm reset criteria:报警复位标准：
?0 : Switch gear will be tripped.0：开关装置会被触发。
?A : The wtg set straight in Local reset.答：风力发电机组设置直接在本地复位。
?B1 : Allowed to remote reset 3 times (in 1 or 6 hours) after which wtg will switch to Local reset.B1：允许远程复位3次（1或6小时）风力发电机组后，将切换到本地复位。
?B2 : Allowed to auto-reset 3 times (in 1 or 6 hours) after which wtg will switch to Local reset.B2：允许自动复位的3倍（1或6小时）风力发电机组后，将切换到本地复位。
?C : Allowed to auto-reset 3 times (in 6 hours) alter which 3 remote resets are allowed (in 6 hours) after which wtg will switch to Local reset.C：3次（6小时）允许自动复
位改变这3远程复位允许（在6个小时）风力发电机组后，将切换到本地复位。
?D : Warning during 72 hours alter switch to Local reset.D：在72小时的警告改变本地复位开关。
?E : Permanent warning.E：永久性预警。
?Auto : The alarm will auto-reset in 5 minutes if trigger conditions disappears.自动：报警器将在5分钟内自动复位，如果触发条件消失。
5.ALARMS报警
1.ALARMS Chart报警图