C.2
c.1
Click middle mouse
Click enter
Double click middle mouse
Click middle mouse
Click middle mouse
Click middle mouse
Click middle mouse exit sketcher
Select this edge Enter 0.25, click enter, click middle mouse
Click middle mouse
Enter 0.75, click enter,click middle mouse
Select boundary of the datum plane
Click middle mouse
Click middle mouse
Select the cylindrical inner surface of the hole
C.3
Select all
Double click
C.5
Click middle mouse
Enter 0.012
Enter 0.06,click enter Double click
C.6
click Flip to change the direction of the arrow. Click OK when the arrows point toward each other.
In the text box that appears in the prompt area, type the clearance (0.04) that will remain between the two parts, as measured along the normal to the selected face of the fixed part, and press [Enter].
C.6
C.6.4
(0,0,0) ENTER
END POINT…(0,0,0.02) CLICK ENTER
Select all done C.7
