Apply an 8N tensile force to the cable in a direction of perpendicular to the axis of
25 °C /80 %RH for 1hr. Upper-Ramp for 0.5hr
65 °C /50 %RH for 1 hr. Down-Ramp for0.5hr,
Total 24 Cycles, 72hrs
Per EIA-364-31B
Mate connectors to expose to 105 ± 2 ℃for 120 hours.
Upon completion of the exposure period, the test specimens shall be conditioned at ambient room conditions for 1 to 2 hours, after which the specified measurements shall be performed.
Per EIA-364-17B, Test condition A
Subject mated connectors into the chamber, the connector shall be mounted on appropriate LLCR boards
and exposed to:
a) Relative Humidity: 70%+/-2% b) Temperature: 30℃+/-1℃ c) Duration: 7
Total : 10 cycles. (13.3hrs)
EIA364-52
Soldering Time:3 +/-0.5sec
Soldering Temperature:245+3/-3℃Immersion in the soldering bath at 0.5mm From terminal tip
Reflow soldering method
Example of 4-Axes Continuity Test FIGURE 4-1 Wrenching Strength
