C &K E 系列
密封小型波动和拉手开关
功能/优点
?密封,以防止焊锡和清洗典型应用
?电讯过程中污染物
?仪表
?防静电电阻,所有驱动器选项?
电脑及周边设备
?摇臂,情况和套管UL 94V-0?
劳斯兼容
规格
DC 最大. q 请与材料(E1X X &E2X X 模型):7.5 A M PS 125 V A C 或28 V DC; 3安培@ 250伏交流电. (
E3X X 型号):5安培125 V A C 或28 V DC; 2安培@ 250伏交流电.请参见第H-37更多收视率.
电气寿命:E1X X 和E2X X 车型:40,000化妆通断
个循环满负荷. E3X X 车型:30,000次.
接触电阻:低于10米
(典型值).初稿@2-4 V DC 100毫安,对于银和镀金触点.
绝缘电阻:109
min.静电放电(ESD )选项:所有驱动器
选项:15,000 2V 以下DC. @海平面,执行器终端.抗电强度:1000 V rms 分钟. @ 海平面.工作温度:-30℃至85℃.
可焊性:根据M IL-STD-202F 方法208D,或
EIA RS-186E 方法9(1小时蒸汽老化).
材料
CA SE 和套管:玻璃填充尼龙6/6,阻燃,耐热
稳定(UL 94V -0).
执行器:尼龙,黑标,内部O 型圈密封标准
所有驱动器.FRA M E :弹簧钢,黑标.
交换机支持:铜或钢,雾锡电镀.执行机构PIV OT 和安装支架:尼龙.执行机构PIV OT RETA INER :不锈钢.
触点&端子:B 触点材料:铜合金,金盘在镍板. q 请与材质:
铜合金,镀银.请参见第H-37更多接触材料.
端子密封:环氧树脂.
硬件:螺母,螺丝,锁紧焊盘圈:不锈钢.
防区外:尼龙标准,铝板,请咨询客服服务中心.
内置A -开关
可用选项显示和H-26到H-39中描述页面
摇臂开关功能
E 101SP 在-NONE-ON E 103SP 开 - 开
E 105SP M om. - 关 - 瞬时.E 107SP 开 - 妈妈.E 108SP 在 - 无 - 妈妈.E 201DP 在-NONE-ON E 203DP 开 - 开
E 205DP M om. - 关 - 瞬时.E 207DP 开 - 妈妈.E 208DP 在 - 无 - 妈妈.E 211DP 开 - 开 - 开E 213
DP 开 - 开 - 妈妈.E 215
DP M om.-ON-妈妈.E 3013P 在-NONE-ON
执行器
J10.531长摇臂J2Lever
J30.906"长摇臂
J11摇臂与框架J21杠杆与框架J500.362"长摇臂
J60Lever J90
Lever
端子
A 直角,PC 通孔
AV2垂直直角,PC 通孔C PC 直通孔Z 焊片
A3直角,管理单元中,PC 通孔
AV3垂直直角,管理单元中,PC 通孔V30.460"高,V 型支架V4.630"高,V 型支架V5垂直直角,PC 通孔V60.460"高,V 型支架V7.630"高,V 型支架V80.953"高,V 型支架
V210.555"高,V 型架,管理单元V310.460"高,V 型架,管理单元
触点材料B 金
K 黄金,锡铅P 黄金,雾锡Q 银
M 银,锡 - 铅S 银,雾锡G 镀金银
L 镀金银,锡,铅R 镀金银,雾锡
Seal E Epoxy
操作杆颜色2黑边框颜色3红
2黑无无需边框颜色金属镜框颜色
(J11,J21执行器)2黑
C&K E系列密封小型波动和拉手开关
SWITCH FUNCTION POS. 1POS. 2POS. 3
CONNECTED TERMINA LS POS. 1POS. 2POS. 3
NO. POLES
MODEL
NO.C&K marking on opposite side
ON
ON
M OM.
ON
ON
NONE
OFF
OFF
OFF
NONE
ON
ON
M OM.
M OM.
M OM.
C&K marking on opposite side
N/A
SCHEMA TIC E101
E103
SP E105
E107
E1082-3OPEN2-1
N/A SPDT
SPDT
Part number show n: E101J1ZBE2
T erminal Nos.
For Reference Only ON
ON
M OM.
ON
ON
ON
ON
M OM.
NONE
OFF
OFF
OFF
NONE
ON
ON
ON
ON
ON
M OM.
M OM.
2-3,5-62-1,5-4
N/A
M OM.
ON
M OM.
M OM.
2-3,5-4
DPDT
OPEN
N/A
E201
E203
E205
E207
DP
E208
E211**
E213**
E215**
DPDT
摇臂
Part number show n: E201J1ZBE2 M OM. = M omentary
T erminal Nos.
For Reference Only
** Wiring for 3-w ay sw itch, Hardw are available seperately, see T echnical Data section of this catalog.
密封小型波动和拉手开关
SWITCH FUNCTION POS. 1POS. 2POS. 3
CONNECTED TERMINA LS POS. 1POS. 2POS. 3
NO. POLES MODEL
NO.C&K marking on opposite side C&K marking on opposite side SCHEMA TIC
3P E301ON NONE ON2-3,5-6,8-9N/A2-1,5-4,8-7
3PDT
3PDT
T erminal Nos.
For Reference Only Part number show n: E301J1ZBE2
M OM. = M omentary
** Wiring for 3-w ay sw itch, see T echnical Data section of this catalog.
OPTION CODE
A CTUA TOR
COLOR
BLA CK
RED
J1LEVER
2
3
Finish: M atte. Other colors, custom actuator mark-
ings and legends available, consult Customer
Service Center.
NOTE:Hardw are: tw o each—mounting screw s,
nuts, lockw ashers and standoffs for 1/8 inch thick
panel are supplied standard on sw itches w ith panel
mounting bracket. Internal o-ring actuator seal
standard. Actuators available separately, see
page H-37. Hardw are available seperately, see
T echnical Data section of this catalog. J1, J2 actua-
tors available w ith C, Z or Z3 terminations.
J2
PA NEL MOUNTING
J1 & J2 Actuators
LEVER 摇臂
C&K E系列密封小型波动和拉手开关
J11ROCKER WIT H FRAM E
OPTION CODE
A CTUA TOR
COLOR BLA CK
RED
2
3
OPTION
CODE FRA ME COLOR
BLA CK
2
NOTE:T his option has reduced anti-static capability.
J21LEVER WIT H FRAM E Actuator finish: M atte, frame finish: gloss.
Other colors, custom actuator markings
and legends available, consult Customer
Service Center.
NOTE:Internal o-ring actuator seal standard.
Actuators & frames available separately, see
page H-37. Hardw are available seperately, see
T echnical Data section of this catalog. N. J11
& J21 actuators available w ith C, Z & Z3 ter-
minations.
PA NEL MOUNTING NOTE:T his option has reduced anti-static capability.
J1ROCKER
OPTION CODE
A CTUA TOR
COLOR BLA CK
RED
2
3
J2LEVER Finish: M atte. Other colors, custom actuator
markings and legends available, consult
Customer Service Center.
NOTE:Hardw are: tw o each—mounting
screw s, nuts, lockw ashers and standoffs for
1/8 inch thick panel are supplied standard on
sw itches w ith panel mounting bracket. Internal
o-ring actuator seal standard. Actuators
available separately, see page H-37. Hardw are
available seperately, see T echnical Data sec-
tion of this catalog. J1, J2 actuators available
w ith A, A3, AV2, AV3, V2-V61 terminations.
摇臂
C&K E系列
密封小型波动和拉手开关
J3ROCKER
OPTION CODE
A CTUA TOR
COLOR BLA CK
RED
2 3
J8 Finish: M atte. Other colors, custom actuator
markings and legends available, consult
Customer Service Center.
NOTE:Hardw are: tw o each—mounting screw s,
nuts, lockw ashers and standoffs for 1/8 inch
thick panel are supplied standard on sw itches
w ith panel mounting bracket. Internal o-ring
actuator seal standard. Actuators available
separately, see page H-37. Hardw are available seperately, see T echnical Data section of this
catalog.
J3 actuators available w ith AV2, AV3
& V2-V61 terminations. Some permissible actua-
tor/termination combinations may lack clearance
betw een actuator and PC board, and care must
be exercised to accommodate this condition.
J50, J60 & J90 actuators available w ith
A, AV2, AV3, V2 – V61 terminations.ROCKER
J50ROCKER J60LEVER J90LEVER